Views: 0 Author: WGT Publish Time: 2022-05-16 Origin: Site
When the helical gear reducer is first installed: why should attention be paid to the alignment of the center shaft of the machine? It can not only prolong the service life of the helical gear reducer, but also ensure that the machine has a good transmission efficiency, and the center shaft error is not greater than the compensation amount of the coupling. When installing shaft drives, use assembly tools to install the drives in the correct manner to ensure the integrity of the internal parts of the helical gear reducer. In choosing a fixed coupling, the manufacturer agrees not to use steel. If the steel is not installed correctly, the machine will not work properly.
After the installation of the helical gear reducer, the installation position of the transmission parts of the machine must be checked effectively and comprehensively to ensure the normal operation and rotation of the machine. Before operation, the helical gear reducer oil level should be filled until it flows out of the screw hole, and then the no-load test should be carried out for about 2 hours. When the machine can run smoothly without vibration, impact, noise or oil leakage, everything is normal and the oil level of the machine needs to be checked regularly.
The smooth and unstable operation of the helical gear reducer depends on whether the base is firm, so as to ensure that the reducer will not produce vibration and noise in the process of operation, and protect the shaft and gear from damage. If the helical gear reducer is driven by a gear or sprocket, it is necessary to install a protective device for the machine to ensure that the output shaft can withstand large loads and protect the safety of the machine.